Comments

john-auvil wrote on 7/11/2011, 9:44 AM

How did you join them?

When you made the project, did you load one video after the other on the same line?

christchurch wrote on 7/11/2011, 10:22 AM

i joined the second one by dropping it into the timeline, one after the other

christchurch wrote on 7/11/2011, 10:25 AM

How did you join them?

When you made the project, did you load one video after the other on the same line?

yes i just dropped the second one into the timeline after the first one, but when i burn it only burns the first part onto the dvd, i am a new user to mep17

john-auvil wrote on 7/11/2011, 10:55 AM

Looking at the timeline from the illustration below, can you verify if your project looks similar? I marked off a red area that indicates the end of the project. If your end point is not at the end, perhaps the burn is only using the material up to that point.

 

 

christchurch wrote on 7/12/2011, 5:16 AM

my end point is at the end, unlike you i have all of the movie on the same line, the movie is 1hr 29mins total but only the first 25mins is burned, when i go to burn it , it appears to be all there but it burns in 5 mins

christchurch wrote on 7/14/2011, 10:04 AM

i don't think my problem has anything to do with the two movies, after reading other peoples problems, it seems to be a common thing only  burning part of a movie, i also get magix not responding part way through a burn then shutting down and restarting again