F9 reset screen arrangement behaviour

johnebaker wrote on 10/31/2020, 6:32 AM

@emmrecs, @Scenestealer, @browj2, @CubeAce

Following from an answer regarding resetting the program interface to its default setting I have found a small bug in MEP 2021 and VPX12.

When dual monitor working, in my case Preview Monitor full screen on one monitor, rest of the interface on the other, pressing F9 does not return the Preview monitor back the the 'Default/Standard' arrangement.

Can any one else replicate this.

Thanks

John EB

Comments

emmrecs wrote on 10/31/2020, 6:39 AM

@johnebaker

Sorry John, I'm still in the "Dark Ages", only one monitor, so can't check this!

Jeff

CubeAce wrote on 10/31/2020, 7:45 AM

@johnebaker @johnebaker

Working at this end in MEP John but puts the whole program onto my Intel powered monitor rather than my nvidia powered monitor where I prefer it to appear.

Ray.

browj2 wrote on 10/31/2020, 8:13 AM

@johnebaker

Hi John,

Tested VPX12 on first start up, F9 worked fine and returned my last setup, dual screen, to the default. However, after playing around with the ShuttlePro settings and mouse, as I indicated in the other thread, F9 and F10 no longer work. I tried MEP2021, same problem.

I'm presently rebooting.

@CubeAce

Try it again, as F9 worked once for me, then not again.

John CB

browj2 wrote on 10/31/2020, 8:48 AM

@johnebaker

After rebooting, all is fine. F9 works in both MEP2021 and VPX12.

Did you try rebooting?

John

CubeAce wrote on 10/31/2020, 8:55 AM

@browj2 @emmrecs @johnebaker

No problem at this end John CB.

Tried four times. Same result though. Always resets fine but switches to my Intel powered monitor.

Ray.

browj2 wrote on 10/31/2020, 9:43 AM

@johnebaker

I tried reprogramming the ShuttlePro again and it did the same thing. Shuttle in Right 1 was changed to Mouse Wheel, modifier Alt. Everything with the ShuttlePro went wonky, and the mouse wheel up/down scrolled vertically. Very strange.

This time, setting it back corrected everything, but I had to switch banks (I have 3 for VPX) and then back to the one that had been changed before it would work properly. The mouse went back to it's normal wheel action.

John CB

johnebaker wrote on 10/31/2020, 11:43 AM

@browj2, @CubeAce

Thanks for testing F9, if I go through the menus I get the same result as when pressing F9.

Needs more looking into as does another 'small' issue - random hanging on start up, cause has been identified just got to try and fix it.

John EB