i brought a microphone and connect it to my computer .. it works but when i open magix music maker mx software the audio was only in the left ear and in the righr ear there was no audio ?? any solutions ??

mastdon0019 wrote on 5/1/2013, 10:11 AM

Comments

johnebaker wrote on 5/1/2013, 4:16 PM

You have a mono microphone which will record on one channel only - this is not a problem.

Once you have recorded the audio you can right click the audio clip and select Audio Effects, Stereo processor, or press the Z key once you have selected the audio, and use the options shown below to duplicate the channel with the sound into the empty channel. In your case select Both channels = left

You can the use the Pan control in the Stereo porcessor to set the audio stage position.

HTH

John

Added - do not know what happened to the image it was there earlier - I have uploaded it again.

mastdon0019 wrote on 5/2/2013, 6:29 AM

Hi

You have a mono microphone which will record on one channel only - this is not a problem.

Once you have recorded the audio you can right click the audio clip and select Audio Effects, Stereo processor, or press the Z key once you have selected the audio, and use the options shown below to duplicate the channel with the sound into the empty channel. In your case select Both channels = left

You can the use the Pan control in the Stereo porcessor to set the audio stage position.

HTH

John