Moving tracks with Sound Forge 13

Clint.Beachwood wrote on 7/30/2020, 5:03 PM

When burning a vinyl album to CD, I am wondering if there is an easier way to do it than what I'm doing. Currently I record the LP, use Markers to separate the songs, then I highlight each track and drag it into the "track list" window. I do this for each track. Is there a way to move all of the tracks at once? This would make life so much easier. Any guidance would be greatly appreciated. Thank you.


rraud wrote on 7/31/2020, 10:59 AM

I do not know about Audio Studio except it cannot burn Red Book CDs . SF Pro has an 'Event' mode which allows moving events (files or segments ot) around independently, like the legacy "CD Architect" (and Vegas). There are a number of ways to convert, insert and edit CD tracks;

Clint.Beachwood wrote on 9/23/2020, 10:18 PM

Hi rraud... thanks for the reply, but it doesn't address my question. My question concerns moving tracks in the active data window down to the "track list" window. That is the question. I am currently moving one track at at time (pretty tedious with 30 tracks) and I'm wondering if there is a way to move all tracks to the track list with one function. I'm not concerned with the actual burning process... I have that down. Thanks. If you can direct me somewhere, that would also be wonderful. thanks again.

James-Lo wrote on 9/28/2020, 5:10 PM

Not sure if this applies to your version of SF, but in SF Pro 13, if you have markers where you want each track to begin, then add one more marker at the end of the last track and execute Edit->Regions List->Markers to Regions. This should replace all of your markers with regions corresponding to each track. Next run Edit->Track List->Create CD Tracks from Regions. I hope this is what you're looking for.